Material Safety Data Sheet

Isopropyl palmitate(IPP) MSDS

Last Updated: 10/27/2017

Created: 05/17/2017

Prepared according to GB/T 16463-2008 and GB/T 17519-2013

 

Section 1 - Chemical Product and Company Identification

Product Name: Isopropyl palmitate(IPP)

CAS#: 142-91-6

Product recommendation and limitation of use:

Widely used in cosmetics, for moisturizing and nourishing the skin. The skin absorption of this product is good, it can contact effectively with the hair follicle in the cortex, penetrate into the deep part of the cortex, and bring the active ingredient in the cosmetics into the skin, and make full use of the active ingredient. As a cosmetic solvent and a skin moisturizer, a penetrant.

Section 2 - Hazards Identification

Emergency Overview OSHA Hazards

No known OSHA hazards HMIS Classification Health Hazard: 0

Flammability: 1

Physical hazards: 0 NFPA Rating Health Hazard: 0

Fire: 1

Reactivity Hazard: 0

Potential Health Effects

Inhalation May be harmful if inhaled. May cause respiratory tract irritation. Skin May be harmful if absorbed through skin. May cause skin irritation. Eyes May cause eye irritation.

Composition Isopropyl palmitate(IPP)

Content 98%

CAS No. 142-91-6

Eye Contact: No known effect on eye contact, rinse with water for a few minute. Skin Contact: No known effect on skin contact, rinse with water for a few minute. Serious Skin Contact: Not available.

Inhalation: Allow the victim to rest in a well ventilated area. Seek immediate medical attention.

Serious Inhalation: Not available.

Ingestion:

Do not induce vomiting. Loosen tight clothing such as a collar, tie, belt or waistband. If the victim is not breathing, perform mouth-to-mouth resuscitation. Seek immediate medical attention.

Serious Ingestion: Not available.

Flammability of the Product: May be combustible at high temperature.

Auto-Ignition Temperature: Not available.

Flash Points: CLOSED CUP: 110°C (230°F).

Flammable Limits: Not available.

Products of Combustion: These products are carbon oxides (CO, CO2).

Fire Hazards in Presence of Various Substances: Not available.

Explosion Hazards in Presence of Various Substances: Risks of explosion of the product in presence of mechanical impact: Not available. Risks of explosion of the product in presence of static discharge: Not available.

Fire Fighting Media and Instructions: SMALL FIRE: Use DRY chemical powder. LARGE FIRE: Use water spray, fog or foam. Do not use water jet.

Special Remarks on Fire Hazards: Not available.

Special Remarks on Explosion Hazards: Not available.

Small Spill: Absorb with an inert material and put the spilled material in an appropriate waste disposal.

Large Spill:

Absorb with an inert material and put the spilled material in an appropriate waste disposal. Finish cleaning by spreading water on the contaminated surface and allow to evacuate through the sanitary system.

Precautions:

Keep away from heat. Keep away from sources of ignition. Empty containers pose a fire risk, evaporate the residue under a fume hood. Ground all equipment containing material. Do not breathe gas/fumes/ vapour/spray. Avoid contact with eyes Wear suitable protective clothing If you feel unwell, seek medical attention and show the label when possible.

Storage:

Keep container dry. Keep in a cool place. Ground all equipment containing material. Keep container tightly closed. Keep in a cool, well-ventilated place. Combustible materials should be stored away from extreme heat and away from strong oxidizing agents.

 

Section 8 - Exposure Controls/Personal Protection

Engineering Controls:

Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their respective threshold limit value. Ensure that eyewash stations and safety showers are proximal to the work-station location.

Personal Protection: Splash goggles. Lab coat.

Personal Protection in Case of a Large Spill:

Splash goggles. Full suit. Boots. Gloves. Suggested protective clothing might not be sufficient; consult a specialist BEFORE handling this product.

Exposure Limits: Not available.

 

Section 9 - Physical and Chemical Properties

Physical state and appearance: Liquid.

Odor: Not available.

Taste: Not available.

Molecular Weight: 298.51 g/mole

Color: Not available.

pH (1% soln/water): Not applicable.

Boiling Point: Not  available. Melting Point: 13.5°C (56.3°F) Critical Temperature: Not available. Specific Gravity: 0.8525 (Water = 1) Vapor Pressure: Not available.

Vapor Density: Not available.

Volatility: Not available.

Odor Threshold: Not available. Water/Oil Dist. Coeff.: Not available. Ionicity (in Water): Not available.

Dispersion Properties: Not available.

Solubility:

Soluble in acetone. Partially soluble in methanol. Insoluble in cold water.

Section 10 - Stability and Reactivity Data

Stability: The product is stable. Instability Temperature: Not available. Conditions of Instability: Not available.

Incompatibility with various substances: Not available.

Corrosivity: Non-corrosive in presence of glass. Special Remarks on Reactivity: Not available. Special Remarks on Corrosivity: Not available. Polymerization: No.

Routes of Entry: Eye contact. Ingestion.

Toxicity to Animals:

LD50: Not available. LC50: Not available. Chronic Effects on Humans: Not available. Other Toxic Effects on Humans:

No specific information is available in our database regarding the other toxic effects of this material for humans.

Special Remarks on Toxicity to Animals: Not available.

Special Remarks on Chronic Effects on Humans: Not available.

Special Remarks on other Toxic Effects on Humans: Not available.

Ecotoxicity: Not available. BOD5 and COD: Not available. Products of Biodegradation:

Possibly short term degradation are not likely hazardous. However, long term degradation products may arise.

Toxicity of the Products of Biodegradation: The products of degradation are more toxic.

Special Remarks on the Products of Biodegradation: Not available.

Waste Disposal:

Waste must be disposed of in accordance with federal, state and local environmental control regulations.

DOT Classification: Not a DOT controlled material (United States).

Identification: Not applicable.

Special Provisions for Transport: Not applicable.

 

 

Federal and State Regulations: TSCA 8(b) inventory: Isopropyl palmitate

Other Regulations: Not available.

Other Classifications:

WHMIS (Canada): This product is not classified according to the EU regulations..

DSCL (EEC): R36- Irritating to eyes.

HMIS (U.S.A.):

Health Hazard: 0

Reactivity: 0

Fire Hazard: 1

Personal Protection: a

National Fire Protection Association (U.S.A.): Health: 0

Flammability: 1

Reactivity: 0

Specific hazard: Protective Equipment:

Not applicable. Lab coat. Not applicable. Splash goggles.

Section 16 - Other Information

References: Not available.

Other Special Considerations: Not available.

Created: 05/17/2017

 

The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and we assume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall wumeichem.com be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if wumeichem.com has been advised of the possibility of such damages.

 

Package&Shipping

Qingdao Bravery International Trading Co., LTD. is located in the beautiful tourist city of Qingdao, is a comprehensive chemical enterprise which doing import and export business. Product range including, API, pharmacy intermediates,food additive,Surfactant ,fungicides and other general chemicals. etc.

With the developing world market, we adhere to the principle of "quality, service, integrity and development" ,Forge ahead,and constantly in pursuit of higher level of product quality and service.

We warmly welcome customers home and abroad to build mutual trust, mutual benefit and stable cooperation relation.

 

General items: import and export of goods; Technology import and export; Food additive sales; Feed additive sales; Sales of special chemical products (without hazardous chemicals); Sales of chemical products (excluding licensed chemical products); Livestock and fishery feed sales; Feed raw material sales; Fertilizer sales; Sales of bio-based materials; Health food (pre-packaged) sales; Food sales (pre-packaged food only); Sales of agricultural and sideline products; Pharmaceutical excipients sales; Drug wholesale

 

 

We could give you:

1.Best quality in your requirement

2.Competitive price in China market with standard high quality or customize

3.mature Technical support，Well-trained and professional technologist and sales with rich experience in the field for 5-10 years

4.Professional logistic support，Free sample and correct shipping documents dispatched according to regulations of different countries

All we want is win-win business. Send your inquiries, you will get it!

 

Why choose us:

1.Factory direct sales, so we can provide the competitive price and high quality product base on 5 years of production and R&D experience

2.It is available in stock for quick shipment. Products could be packaged according to customer’s specialized requirements.

3.The products can be transported by Courier, air or sea.

4.Customers will receive the most professional technical support and efficient service.

5.Any inquiries will be replied within 24hours.

6.High purity with test report.